Dismantle extruder not heating

Post Reply
bernat
Posts: 2
Joined: Tue Dec 29, 2020 5:47 pm

Dismantle extruder not heating

Post by bernat » Tue Dec 29, 2020 5:50 pm

Hi guys

I had to disassemble the extruder to see why it was not heating. I have seen that the extruder cables were out of the green strip, but I don't know where to put them.
Can you tell me?

Thank you

Delores
Posts: 1
Joined: Mon Dec 21, 2020 5:23 pm

Re: Dismantle extruder not heating

Post by Delores » Tue Dec 29, 2020 7:29 pm

I recommend first removing the nozzle. Then,from the top, hold the drive gear open and gently work the drill bit down, removing often to clean off debris. If the bit is long enough, sooner or later it'll project out the hole where the nozzle fits. If not, gently work from the bottom up.











MyGroundBiz Login
Last edited by Delores on Wed Dec 30, 2020 1:53 pm, edited 1 time in total.

bernat
Posts: 2
Joined: Tue Dec 29, 2020 5:47 pm

Re: Dismantle extruder not heating

Post by bernat » Tue Dec 29, 2020 7:55 pm

I have everything disassembled but the estruder cables do not know where they go?
WhatsApp Image 2020-12-29 at 12.50.00.jpeg
WhatsApp Image 2020-12-29 at 12.50.00.jpeg (249.59 KiB) Viewed 5532 times

SibiVikki
Posts: 1
Joined: Tue Mar 09, 2021 8:41 pm

Re: Dismantle extruder not heating

Post by SibiVikki » Tue Mar 09, 2021 9:25 pm

I was able to remove the filament and went to again load. The process started UFABET but again the "heating" stopped at slightly past half.

Post Reply