Problem with A20 and Overhang

Post Reply
Zakzak3d
Posts: 3
Joined: Fri Nov 06, 2020 6:14 am

Problem with A20 and Overhang

Post by Zakzak3d » Sun Nov 22, 2020 9:37 pm

Hi all,

I have a Geeetech A20 and I struggle to get out clean overhangs, I tested to print a temperature tower, but I still have the same problem, the pla is curving upwards and it doesn't matter temperature.
Do you have any leads for me to resolve this problem.
Thank you for your help !
127236502_10158753451299417_2190868796134562405_o.jpg
127236502_10158753451299417_2190868796134562405_o.jpg (38.81 KiB) Viewed 6276 times
126945261_10158753451549417_4312718875498935592_o.jpg
126945261_10158753451549417_4312718875498935592_o.jpg (44.99 KiB) Viewed 6276 times
126910316_10158753451209417_2509540547769375072_o.jpg
126910316_10158753451209417_2509540547769375072_o.jpg (66.42 KiB) Viewed 6276 times
Top
Zakzak3d
Posts: 3
Joined: Fri Nov 06, 2020 6:14 am

Re: Problem with A20 and Overhang

Post by Zakzak3d » Mon Nov 23, 2020 1:02 am

After many try I think I have found the solution, it's look like I haven't a fan duct near the Nuzzle to cool the model, Do you know where I can found 3d model to print a fan duct for the fan :
Attachments
127025931_10158753685889417_1339961833719443960_o.jpg
127025931_10158753685889417_1339961833719443960_o.jpg (130.72 KiB) Viewed 6269 times
Top
Post Reply

Return to “Geeetech A20”