Nothing will stick
Posted: Thu Feb 06, 2020 3:58 am
Hello everybody.
I have purchased a A20 printer and have assembled it correctly.
Additionally I bought White PLA from Geeetech.
I have the problem that the first layer will not stick, whatever I try.
I thought this was a leveling issue, so I bought a 3D Touch Autoleveler and set it up properly, but even that didn't help. I have tried everything I could find about this on the forum, but nothing helped. I printed via SD, I tried to use the Geeetech software to print.
My initial thought was that the bed is too cold at 50°, so I tried to set it to 80° once via software and once in the printer itself. The printer completely ignored that setting, and kept heating the bed up to 50° and no further.
Also, while the nozzle preheats, some of the filament comes out already and when the printer starts printing the first layer, that filament pushes everything that is printed off the bed.
At this point I have no clue what else I could and am really frustrated.
Thanks in advance for any answers.
I have purchased a A20 printer and have assembled it correctly.
Additionally I bought White PLA from Geeetech.
I have the problem that the first layer will not stick, whatever I try.
I thought this was a leveling issue, so I bought a 3D Touch Autoleveler and set it up properly, but even that didn't help. I have tried everything I could find about this on the forum, but nothing helped. I printed via SD, I tried to use the Geeetech software to print.
My initial thought was that the bed is too cold at 50°, so I tried to set it to 80° once via software and once in the printer itself. The printer completely ignored that setting, and kept heating the bed up to 50° and no further.
Also, while the nozzle preheats, some of the filament comes out already and when the printer starts printing the first layer, that filament pushes everything that is printed off the bed.
At this point I have no clue what else I could and am really frustrated.
Thanks in advance for any answers.