Printer bypass temperature setting by Cura

Post Reply
OrazioGiunta
Posts: 10
Joined: Wed Jan 13, 2021 11:53 pm

Printer bypass temperature setting by Cura

Post by OrazioGiunta » Tue Jan 11, 2022 4:38 pm

Cura slicer works well with my Geetech. I've noticed that A20 bypass the temperature set point that I had set in Cura slicer. I've the last firmware on. Do you have any advice ?

Warchlock
Posts: 1
Joined: Tue Jan 25, 2022 11:41 pm

Re: Printer bypass temperature setting by Cura

Post by Warchlock » Tue Jan 25, 2022 11:44 pm

OrazioGiunta wrote:
Tue Jan 11, 2022 4:38 pm
Cura slicer works well with my Geetech. I've noticed that A20 bypass the temperature set point that I had set in Cura slicer. I've the last firmware on. Do you have any advice ?
I have the same problem here, Im not sure if its only the temp though - Im thinking its overwriting every setting, including speed, retraction, etc. Any Idea?

Post Reply