Geeetech

perfect thanks

Hi,

I've lost one of the 2 screw that are in the stepper motor. I need to buy new one, but don't know what to buy. Can you tell me what is it? Or what screw size i can use?

Here are the picture, this is the small black screw for the head of the stepper motor

thanks

Hi, Thanks to your help, i have finished to work with my Prusa I3 Pro C. Now, it seams to work. And i begin to print my firsts objects. To be sure of calibration, i used a file i found on internet, specially to test your printing calibration etc. http://www.thingiverse.com/thing:13053 Here is the re...

Ok, this works better!

thanks

Hi, I have a problem with my prusa i3 pro C. The extruder are configurated in the wrong order. When i use repeatier host to extrude, it retract. When i want to retract, it extrude. Result is i cant print. What do i have to change in the firmware? I supposed this is here #define INVERT_E0_DIR true //...

Hi, Thanks again for your help It seams OK now, except a little noise so i need to add lubricant I have others problem now that i tryed to print ;) I have tryed to print, and nothing goes out of the printer. I put in place the ABS, heating the extruder and bed. I tryed to print a bed calibration fil...

Yes!! this was it!! I have inverted the Z and Y end stop on the board!! Thanks for help Did you manage to see the video i sent you? If not, can you tell me how to send you a video? Cause on it, you can see the noise that make the Z axies while moving (not when block, but when regularely moving) I th...

Thanks for your answer. I downloaded the firmware, i have change the INVERT_X. Now it's OK, it goes on the right side, like it should! For the other problem, Z axies, nothing work. I have put in higher, in several position, it always goes the same way. I have put you a video of the end of the HOME p...

Hi Thanks for your answer. 1) For the Z-Axies, here is a picture. Like asked, i have change the level on the bed by hte 4 wings nuts benath the bed. Now the extruders are not touching it anymore!! Good!! BUT it not solved yet. Like you can see in picture, the extruders are at the max bottom level, t...

Hi, I finished to build my prusa i3 pro C, dual extruder, but i have severals problems First and most important, is , i think, a calibration problem. When i use the software Repeater-Host, and put axes into Home Position, i have 2 problems: - Z axies try to go down to much, touch the bed, and almost...