Geeetech

Hi Przepka 1985, Thanks for the advice. I had already gleaned most of this information from the internet, but was still having problems. I was unable to move Z below Zero. I remounted the 3D Touch using a £1.00 coin as a <>3mm spacer, and by using your advise re turning off the Z endstop, was able t...

Hi, I don't know if anyone has had a similar problem, but my A10 printer's Z axis was OK, but suddenly it would not go down low enough to the bed! I have a 3D Touch connected, and this is working OK. It appears that the Z drive has slipped, and the printer thinks it at zero Z when it is about 4mm of...

Hi,

I have a A20, and am using Repetier Host, and am also new to £D printing. but after installing BL Touch, I got a similar message.
As you have probably realised, if you ignore the message, just press continue, and the printer works fine.
Regards,

Hi all, I have a Geeetech A20 and get good results using Geeetech PLA. This sticks to the Black stick on surface supplied without glue of any sort. However, when I tried a print with a Generic Silver PLA, it refused to stick! I tried PVA, Pritt stick, and hairspray. I also tried various temperature ...