Search found 3 matches

by Volans
Fri Feb 21, 2020 2:30 am
Forum: Geeetech A10 Series
Topic: Printing issues with my A10!
Replies: 2
Views: 743

Re: Printing issues with my A10!

It looks like bad filament to me. If the nozzle pops and sputters in those bad areas, there is likely moisture in the filament. Try a fresh spool or try to dry it out. I use Inland PLA a lot because I live near a Micro Center. I live in Denver, CO so moisture isn't a big concern to me. If you don't ...
by Volans
Sun Feb 16, 2020 10:59 am
Forum: A20T
Topic: GT2560 V4 Connections for Installing Bootloader
Replies: 9
Views: 3830

Re: GT2560 V4 Connections for Installing Bootloader

EXACTLY my question too. Vert says here to "press and hold reset when you flash..." PLEASE CLARIFY this statement Do you mean hold down the reset during the entire upload process and don't release until it completes? I haven't been doing that part. Guess I will try to begin holding the reset button ...
by Volans
Sat Feb 15, 2020 9:50 am
Forum: Control Board
Topic: GT2560 V4.0 motherboard wiring diagram
Replies: 14
Views: 12585

Re: GT2560 V4.0 motherboard wiring diagram

That is a nice layout for all the common connections to drive a printer. I have been looking for information regarding where I may connect a USBASP board to flash a new bootloader on a GT2560 v4.0 motherboard. This wiring diagram has not helped in this regard. I have seen references to connections a...