Search found 5 matches

by Liizok8u
Tue Feb 18, 2020 7:28 pm
Forum: Hot bed
Topic: Hotbed does not heat anymore (no power)
Replies: 3
Views: 5656

Re: Hotbed does not heat anymore (no power)

:D Hi, Are you referring to the fact that the heated bed itself cannot be heated? Yes You can check the temperature indicator by unplugging the hot-bed wire from the motherboard. If -14 is displayed, measure the thermistor on the hot bed. It does say -14. How would I measure the thermistor? regards
by Liizok8u
Wed Jan 22, 2020 3:05 am
Forum: Hot bed
Topic: A20m Updated model, new Heatbed with Mylar?
Replies: 3
Views: 3356

Re: A20m Updated model, new Heatbed with Mylar?

but its much thicker, appears to be 4mm thick (probably reduces heatbed warping significantly) and a Mylar Sticker instead of a glass clip-on buildplate. Yeah, my heatbed is 4mm, but the mylar is crappy. :/ Wish i had the superplate. The mylar started bubbling in the middle. I just put a 260*260*4 ...
by Liizok8u
Wed Jan 22, 2020 2:58 am
Forum: Hot bed
Topic: Hotbed does not heat anymore (no power)
Replies: 3
Views: 5656

Hotbed does not heat anymore (no power)

Hey, from one print to another, my heatbed does not heat anymore. :/ I messured the voltage at the powercord and there is no 24v coming in. I opened up the printer and found this heatbed board. It has 24v coming in from the power supply (working) and it recieves 24v from the mainboard, when I set th...
by Liizok8u
Wed Jan 22, 2020 2:52 am
Forum: Assembly
Topic: How to square gantry in A10,A20,etc
Replies: 1
Views: 3528

How to square gantry in A10,A20,etc

Hey, i allways wondered why even with perfect bed leveling, my prints didn't turn out great. With my square I noticed, that the hole gantry is tilted a quiet noticeably to the back. I tried to unscrew it (on the bottom) and straighten it. But when I tighten the screws, the gantry tilts backwards aga...