Geeetech

Jarda3d wrote: ↑

Sat Jan 04, 2020 10:30 pm

No. 2???

On my A10M it was configuration No.1 from factory (2018/10 model). Warm flow is going to printed model.

So what is right in reallity?

I don't think the fans on the sides go to the model. It's the 3rd fan's role, the one with a duck to cold the print. Maybe I'm wrong ?

Thanks for answer.

My question is more about the direction of the air flow of each fans. Is it from inside the hotend to the outside or vice versa ?

I tried to draw my question, see files below

What is correct ?

Hello, I'm new to 3D printing. Recently, I had a problem with the hotend so I replaced it. But I don't take care about the 2 fans placements. Since, my printer often pause printing without error message. I just have to select "Resume" to continue but it's a little bit annoying for long prints. I sus...