Search found 3 matches

by krmmr
Wed Aug 21, 2019 8:21 pm
Forum: Geeetech A20M
Topic: Heating failed & Dual Extrusion not working
Replies: 1
Views: 505

Heating failed & Dual Extrusion not working

Now after i tightened the knob at the extruders and set my e-stops/mm to a higher value i get "fine" extrusions.. BUT After some time the printer stops saying Heating failed. I tried printing the dice two times, one time it put out this message on the 2nd or 3rd layer the second time it stopt at the...
by krmmr
Fri Jul 19, 2019 2:51 am
Forum: Geeetech A20M
Topic: Filament of E0 can't pass through & Disable Mixing
Replies: 2
Views: 401

Re: Filament of E0 can't pass through & Disable Mixing

Thanks will try that.. and what about my problem that the printer only prints what is set in the Mixer option on the printer and not what i define in Cura?
by krmmr
Thu Jul 18, 2019 5:32 pm
Forum: Geeetech A20M
Topic: Filament of E0 can't pass through & Disable Mixing
Replies: 2
Views: 401

Filament of E0 can't pass through & Disable Mixing

Just got a new A20M and did 2 Prints. The Dog which was on the SD Card with the Mixing function which turned out quite cool. Then i printed a Statue in a filament using E1. Today i tried printing a lizard with two Colors (sliced using Cura). But the A20M always used the one Color i set the Mixing op...