Search found 4 matches

by SamuraiMelon
Sun Aug 18, 2019 5:32 am
Forum: Geeetech I3 Pro B
Topic: Extruder Leakage
Replies: 2
Views: 355

Extruder Leakage

Hi, I seem to be getting quite a bit of filament leakage, oozing plastic out of the extruder heating block, onto the nozzle. (This melted plastic then drips down interrupting prints). IMG_20190815_232210.jpg Anyone experienced this issue/know what's causing it? Will I need a replacement? Many thanks
by SamuraiMelon
Mon Jul 22, 2019 9:33 pm
Forum: Geeetech I3 Pro B
Topic: First Time 3D Printing
Replies: 5
Views: 1193

Re: First Time 3D Printing

Hi, the only firmware on the official website is in a hex file, and I'm not sure how to use the hex file for firmware upload. Yes, I have made sure its not clogged, I can manually push the consumable through when at 200 degrees, when trying to manually extrude (either over USB or from LCD panel), th...
by SamuraiMelon
Sun Jul 21, 2019 11:04 pm
Forum: Geeetech I3 Pro B
Topic: First Time 3D Printing
Replies: 5
Views: 1193

Re: First Time 3D Printing

Hi, No matter how far I install the limit switch, when I home the printer, it seems to hit the end stops correctly (and therefore home correctly), however, when printing, the extruder hits the end stop, and just seems to want to keep going down regardless of hitting the end stop (until it inevitably...
by SamuraiMelon
Sat Jul 13, 2019 7:20 am
Forum: Geeetech I3 Pro B
Topic: First Time 3D Printing
Replies: 5
Views: 1193

First Time 3D Printing

Hi, Got a I3 Pro B 3D printer as a gift recently, and I *successfully* assembled, firmware uploaded, all axis move as they should (tested in EasyPrint 3D), however, I'm not sure about calibrating it i.e. extruder/heat bed distance. When I home the printer, the extruder moves to this position seen in...