Search found 3 matches

by Bluesandbox
Thu Feb 27, 2020 8:08 am
Forum: Geeetech I3 Pro C
Topic: adjusted driver voltage from .8 to 1 now x axis dosnt move and x driver gets very hot
Replies: 1
Views: 2561

adjusted driver voltage from .8 to 1 now x axis dosnt move and x driver gets very hot

I adjusted the voltage for all the drivers from.8 to 1 because the motors could barely push filament (i could easily push manually), now the x-axis doesn't move and the driver for it gets very hot and reads 0.5 volts. I switched the wire to the y-axis and it won't move either, so it isnt the wire or...
by Bluesandbox
Thu Feb 27, 2020 12:07 am
Forum: Geeetech I3 Pro C
Topic: acrylic i3 pro c z lead screws un-align every time it moves
Replies: 1
Views: 2341

acrylic i3 pro c z lead screws un-align every time it moves

every time I either push the x gantry all the way up to level it (with the x endstop removed, it makes one end higher) and try to move it again, it goes good for about 20 mm but then gets unaligned and jams. is it something wrong with the current supplied to the z stepper motors?
by Bluesandbox
Fri Aug 23, 2019 3:14 am
Forum: Extruder
Topic: Acrylic Geeetech i3 pro c not extruding
Replies: 1
Views: 1610

Acrylic Geeetech i3 pro c not extruding

i recently purchased and assembled a acrylic i3 pro c and the extruders arnt moving at all or even trying to move. I have tried switching the cables from 1 extruder to the other but nothing wil make them move. Everything else seems to work fine. i have plugged the extruder into a plug for one of the...