Search found 4 matches
Search found 4 matches • Page 1 of 1
- Sun Feb 16, 2020 11:29 am
- Forum: Geeetech A10 Series
- Topic: A10M to single extruder
- Replies: 0
- Views: 1052
Has anyone taken their A10M to a single extruder style maybe E3D or something like that. I just can't get any stable printing out of the ATM m as it is with dual setup. Also thinking about going direct drive on that extruder if I go signal. Thoughts?
just refferig to the aluminum plate now the glass. my other printers have thicker NOT bendable aluminum heater plates. just wondering if this thin plate with the A10M is normal? or should i have a thicker one? glass or not it would be easier to level if the aluminum under the print surface was not b...
The glass on top is 1/4 inch thick but the aluminum heater plate below that is really this and is not really flat. Shouldn't that aluminum heat plate he thicker to remain flat better?