Search found 189 matches

by Jarda3d
Sun Jul 05, 2020 8:23 am
Forum: Geeetech A10 Series
Topic: A10M 2 filament not mixing well
Replies: 14
Views: 2020

Re: A10M 2 filament not mixing well

Put a tiny spring into hotend tip (yes, inside!) to mix filament more better.

Pitfalls:
- lower volumetric speed
- another retract or totally bad, depend on your spring.
by Jarda3d
Sun Jul 05, 2020 8:09 am
Forum: Geeetech A10 Series
Topic: Downgrade from A10t to A10
Replies: 1
Views: 318

Re: Downgrade from A10t to A10

Yes, but why?
by Jarda3d
Sun Jul 05, 2020 8:04 am
Forum: A20T
Topic: Magnetic Hotbed
Replies: 9
Views: 6687

Re: Magnetic Hotbed

Use Geeetech SuperPlate and you will get out all problems with sticking.
by Jarda3d
Sun Jul 05, 2020 7:51 am
Forum: Geeetech A20M
Topic: Incomplete upper surface
Replies: 1
Views: 282

Re: Incomplete upper surface

Try my profile, you can use it without changes but hotbed is smaller as A10M have it.
by Jarda3d
Sun Jul 05, 2020 7:44 am
Forum: Geeetech A20M
Topic: New A20M couple of problems?
Replies: 1
Views: 374

Re: New A20M couple of problems?

It could be cable problem. Contact oxidation is one of known shipping problems with Geeetech.
by Jarda3d
Sat Feb 01, 2020 4:42 am
Forum: Geeetech A10 Series
Topic: Leveling bed with glass platform
Replies: 2
Views: 757

Re: Leveling bed with glass platform

use screw dials on hotbed. Or push Z switch slightly higher, but not reccomend 5mm but 3-4mm only, adjust via bed then.
by Jarda3d
Tue Jan 21, 2020 7:53 am
Forum: A30M
Topic: Purge Bucket for A30m?
Replies: 1
Views: 1240

Re: Purge Bucket for A30m?

by Jarda3d
Tue Jan 21, 2020 7:44 am
Forum: A30M
Topic: A30M Poor Colour Mixing
Replies: 2
Views: 1167

Re: A30M Poor Colour Mixing

Black need lower temp, white higher. But mixing is possible. Stringing is terrible.... The mixing coulours what you find is FEATURE of mixer hotend. Solution to have smooth colours is possible (look at my messages here, described few weeks ago), but chinese sellers sell me steel nozzles instead of b...
by Jarda3d
Tue Jan 21, 2020 7:36 am
Forum: A30M
Topic: TPU not Working with A30M
Replies: 5
Views: 1727

Re: TPU not Working with A30M

Suitable, but with very low volumetric speed. And possible you need to lubricate filament (use drop of gun oil to filament filter).