Geeetech

Tried now the 1.1.9 marlin The problem G28 always homes about 8mm above the bed M211 S0 - softwarendstopp disabled leveled G92 Z0 - Z to 0 M500 - remember this M211 S1 - softwareendstop enabled G1 Z10 - 10Up G1 Z0 works now but if G28 then nozzle is 8mm above the Bed, Display says Z 0 Must i disconn...

sorry for the late reply,
S3D send me a profile, that works

attached

I want to disable the touch sensor. Installed a marlin 118 without Touch But it'll not work EEProm deleted Leveled with a peace of paper, after G28 the nozzle is 8mm above the bed ?!?!? M211 S0 - softwarendstopp disabled leveled G92 Z0 - Z to 0 M500 - remember this M211 S1 - softwareendstop enabled ...

I have also many prob printing with a10m only the first print, two colored dog from sd, was great What slicer do you use? I'm trying to print something with s3d 4.1.1 I can print with extruder 1, printing with extruder2 gives the error 104 wrong extruder, sometimes also error 109. Same error appears...

Problem isn't to find the FAN Control, problem is that you can not control the fanspeed even not over the display.
There is no faster or slower reaction by the fan.

I found no way to lower the Speed at cura or s3d.
Does not work.

I'll install 2 * 12V Silent Coolteks at one 24V line, cause teh A10m has 24V Fans.
Therefore i must modify Printhead or find on @ Thingiverse

Thanks, i'll take a look at it,
but since i'm using S3d also for my Any i would prefere to use S3d for all of my printers

I'd tried ist hours but the nozzel is always to near to the bed I found this as a discription to level BL Touch ; preheat for working temperatures M502 ; optionally reset to firmware settings M500; save M851 Z0 ; reset any z-offset G28 ; home all G1 X117 Y117 ; move nozzle in center M211 S0 ; disabl...

I've many Problems to using Simplify3d to print with only one filement, left or right side.
Are there somewhere some settings for Simplify3d ?

*.hex with cura (or other proggies)
*.ino with Arduino
undér windows