Geeetech

Hello
Why do you build a motherboard V4.1 with direct driver in the A20?

Is the firmware A20T to TMC 2208 for X Y Z or also for E0 E1E2

mfg

Hello
I would like to switch the extruder to metal.
Which can I take from Amazon

Hi there
How can you set the extruders individually.
Extruder 0 - 9.5 cm
Extruder 1 - 9.0cm
Extruder 2 - 7.5cm
If I only want to print with extruder 2, the printing will be very bad.

Hi there

I wanted to test Repetier A20M and A20T

Set like on Hompage Geeetech.

However when I load a file and I say print with exdruder 2 it prints with extruder 1.

HI
Thank you
But I wanted the config.h with 3d touch because I can set it to German.
I would like to use Arduino 1.1.9 or 2.0

HI
I do not find it

Thank you

I want to flash my A20M on Marlin 2.xx with Arduino.

Who has conf.h and conf.adv for me. with 3dtouch.

Hi there
Yes i would need help.
I have installed the firmware of geeetech with 3d touch since it doesn't work anymore. Always do a reset.
I also can not install the firmware without 3d touch