Search found 4 matches

by Sloopy
Tue Mar 27, 2018 9:04 pm
Forum: Print Quality
Topic: Print Layers Too Thick
Replies: 3
Views: 3208

Re: Print Layers Too Thick

I noticed the strange offsets were spiral in nature and I think one of the threaded rods are bent. You might be able to tell from the photo that the legs look like a spiral. I've ordered some lead screws to replace and plan to change the steps/mm accordingly. Straightening the rod proved fruitless a...
by Sloopy
Tue Mar 27, 2018 3:13 am
Forum: Print Quality
Topic: Prusa I3 Pro W
Replies: 4
Views: 4037

Re: Prusa I3 Pro W

Thank you. After reviewing the photos again and comparing them to mine, they may not be the same issue. If you would refer to my post in the forums, I have a picture posted. The issue is what looks like ribs? Waves? The legs on the chair look like a spiral and the whole thing looks like it was creas...
by Sloopy
Mon Mar 26, 2018 6:07 am
Forum: Print Quality
Topic: Prusa I3 Pro W
Replies: 4
Views: 4037

Re: Prusa I3 Pro W

Can you repost the answer here? I am having a similar problem.

-MS
by Sloopy
Mon Mar 26, 2018 6:04 am
Forum: Print Quality
Topic: Print Layers Too Thick
Replies: 3
Views: 3208

Print Layers Too Thick

Good afternoon. I just assembled my Geeetech Prusa I3 Pro W and I am having some quality issues. The layer resolution seems to be way off. I have it set in Cura to 0.1mm but the prints look closer to a 1mm layer height, but print at a 0.1mm resolution. The photo below should give you an idea of what...