Geeetech

Hello Ken. :mrgreen: In your case, he proposes two things: check if the bowden tube is pushed down to the very end of the throat (it must be evenly cut) , conduct a test in which you will use the black filament in both extruders and then another white one. For easy control, draw a line at equal inte...

Hi. :mrgreen: My request was special... I think you already know why. ;) Basically, when you look at these elements in different offers, the vast majority of them have five leads. Two of them are temperature measurements. The other three are responsible for preparing the connections for different su...

Hello.


I'd like to see a picture of all the soldering pads on your heated bed.

Hello.


That's very bad.

Consult your salesman. Tell him about the problem.

Hi Macflame.


Thank you for the good word.
There is never too much of that.

In the course of the first tests, the electronics were as follows:
.

Hi RBandeira. :mrgreen: It's nice to hear you're going to solve your problems yourself. ;) Change the nozzles as you like, carry out various tests. :idea: This way you will become an expert faster. If you own a new printer, keep in mind it has to work. Due to this, all the mechanisms will be able to...

Hello.


Try uninstalling the old COM port and removing the driver files at the same time.
Restart the system and reinstall the driver.

Is it really that difficult to enter a query in the search engine on the forum

Fans, 2 wire or 3 wire, Again

Hi.


Oh, no problem.

The resistance limiting the short circuit current of the tact switch is also important.
It is already present in your circuit diagram because you have an LED.