Geeetech

Cancel my question. The problem is that the ribbon cables have to be reverse from the original position by shaving down the guides.

Cancel my question. The problem is that the ribbon cables have to be reverse from the original position by shaving down the guides. Hello and thank you for the firmware. What should I do with an echo:SD init fail error. My board is hanging on echo:SD init fail and the LED will not power on. I'm usin...

Cancel my question.

All steppers work and can be operated via Repetier-Host manual. I really believe the issue is with the LCD/SD Reader.. I've tried both (attached)

Can someone help me figure out why my I3 Pro B will not load up with the available firmware? The only significant change is that I had to replace the stock GT2560 A with a new GT2560 A+ control board. I have tried a few different firmware available in the Geeetech forums with no luck. I can confirm ...

Hello and thank you for the firmware. What should I do with an echo:SD init fail error. My board is hanging on echo:SD init fail and the LED will not power on. I'm using a GT2560 A+ board and made the following changes. SERVO0_PIN from 32 to 11 in pins_GT2560.h comment out the following three values...

Hello,

What should I comment out if I do not have a probe installed???

You have provided the only firmware for the GT2560 A+ board that I have. I've replaced the original board in order to store my settings via the EEPROM and the lack of bootloader on the original makes that a pain.

I've already installed this one along with a new hot end https://reprapchampion.com/products/3d- ... son-reprap

Hello, I'm looking for some guidance on upgrading my I3 Pro B Extruder to a Kysan 5.18:1 Planetary Geared Stepper Motor Nema17 (or similar). I've already changed out the system to a bowden feeder and hotend. What I dont' know what/how to do is determine: - what stepper driver is needed - what is com...