Geeetech

lvet "Thank you so much for your brilliant work on adapting Marlin on the i3 Pro B. Just a question. Which software should I Install? Marlin-1.1.9_bugfixes_02102019 or Marlin-bugfix-1.1.x" Marlin-1.1.9_bugfixes_02102019 - that one is my custom version I'm using The other link is for pure (without an...

@pastranario3 - you have to change the values defined by DEFAULT_AXIS_STEPS_PER_UNIT - just copy these values from your current Configuration.h file and replace it in new config file /** * Default Axis Steps Per Unit (steps/mm) * Override with M92 * X, Y, Z, E0 [, E1[, E2[, E3[, E4]]]] */ //#define ...

Hi, I think you should be fine using that firmware I uploaded - there is not too much in the board configuration - there is one file which is define servo pins when you will open this file pins_GT2560_REV_A_PLUS.h you will see only few files - the original fine doesn't for me as well before (the Z w...

Hi If you guys interested here is latest Marlin Firmware I prepared for my Geeetech i3 Pro B with BLTouch bed leveling sensor. My printer is using GT2560 A+ motherboard - using pin 11 for BLTouch (original firmware is using pin 32 but it doesn't work on my device). Spent a lot of time troubleshootin...

oh yeah no problem at all - would be more than happy to help other if only would be able

No problem - hope someone will find it useful :-) - that upgrade was worth all the money and time I spent on it - prints are much much better than before :-)

Hi If you guys interested here is latest Marlin Firmware I prepared for my Geeetech i3 Pro B with BLTouch bed leveling sensor. My printer is using GT2560 A+ motherboard - using pin 11 for BLTouch (original firmware is using pin 32 but it doesn't work on my device). Spent a lot of time troubleshootin...

I think they had some bug in the definition and they used ULTIMAKER before - I'm using BOARD_GT2560_REV_A_PLUS as Motherboard (line 1221 in configuration.h file #ifndef MOTHERBOARD #define MOTHERBOARD BOARD_GT2560_REV_A_PLUS #endif however I had to change servo pins in pins_GT2560_REV_A_PLUS.h file ...

Thanks Solo for all updates - going to download latest FW and see how it will work ... I had some calibrate issues too but I think BLTouch is working - check if your Z axies motors are moving back and fort during printing if these are not moving then the firmware did not applied leveling settings .....

I had the same problem with my firmware - I;m using GT2560 A+ board and had to change pin in the pins_GT2560_REV_A_PLUS.h file First I had to include that file in configuration.h file (default was ultimaker) and then changed pins in the pins_GT2560_REV_A_PLUS.h file - it was pointing to pin32 and I ...