Search found 7 matches

by slipknot28
Wed Sep 04, 2019 2:35 am
Forum: Geeetech A30 Series
Topic: z axis vibration
Replies: 8
Views: 3427

Re: z axis vibration

I am using this anti tremble "things" and everything is now silent.

https://www.thingiverse.com/thing:3111251
by slipknot28
Thu Jul 25, 2019 2:27 am
Forum: Geeetech A30 Series
Topic: Advice and opinions needed before purchase!
Replies: 6
Views: 1185

Re: Advice and oponions needed before purchase!

I totally agree with Mitch95.

I also have A30 and it is solid made but problem is firmware which is not Marlin.
In Marlin firmware you can change lot of things to make your printer better but with Smartto firmware you can only wait geeetech to release new firmware (if ever).
by slipknot28
Fri Jul 19, 2019 3:27 am
Forum: Geeetech A30 Series
Topic: A30 silent fans
Replies: 4
Views: 1414

Re: A30 silent fans

Hi,

I am using something similar. I remixed CR10 fan case with two 120 mm fans, but i didn't disconnected all fans.
I just disconnected power fan and removed power supply cover.

http://www.thingiverse.com/thing:3712312

Best regards
by slipknot28
Wed Apr 17, 2019 1:48 am
Forum: Geeetech A30 Series
Topic: Metal/Alu extruder feeder
Replies: 4
Views: 903

Re: Metal/Alu extruder feeder

I bought two of this on ebay and they work without any problems.

Image
by slipknot28
Sat Jun 03, 2017 1:56 pm
Forum: Mods And Hacks
Topic: 3D Touch invert Z
Replies: 2
Views: 2353

Re: 3D Touch invert Z

Because I set bed leveling manually there is no point of taking video. Now on video you can not see anything. I really do not want to readjust bed again to make a video. My Z offset iz set to -1,4 with M851 command (also tried set it trough configuration.h file). These are readings after G29: 08:51:...
by slipknot28
Fri Jun 02, 2017 2:28 am
Forum: Mods And Hacks
Topic: 3D Touch invert Z
Replies: 2
Views: 2353

3D Touch invert Z

I have a problem with setting 3D Touch. I tried with every firmware that I found. I also tried with a capacitive sensor. 3D Touch and Capacitive Sensor work smoothly. After the G29 command I get the measurement results. Thereafter a problem occurs. At a point where the head should go down, it raises...
by slipknot28
Thu Jun 01, 2017 1:38 am
Forum: Mods And Hacks
Topic: 3D Touch working ... but not totally
Replies: 4
Views: 6351

Re: 3D Touch working ... but not totally

I can not see on the video is pin down (because red light is on which means that pin is up).
If pin is not down I think only problem you have is that your sensor is too low.

Raise the sensor a bit and everything will be ok.