Geeetech

Yes, originally the extruder motor was the one having the issue. I swapped the that stepper motor driver with the one for the x-axis and then x-axis had the same issue and the extruder motor was fine. It would only move in one direction, I think this was because the driver wasn't supplying enough po...

Ok, I just wanted to verify that. I think I received a faulty stepper motor driver then, because even turning the potentiometer a 1/16 turn in either direction drops the voltage down to 0 or 4.6 there is no middle ground. I cannot get it set to 0.8-1.2 V.

I did home the printer when trying this. After homing I was not able to move the x-axis to the right it would only move the the left when I tell it to move left after manually moving the motor to the middle. I tried moving the x-axis through both the computer interface and the printer's interface. I...

I recently purchased a GEEETECH 3D Printer Pro B and was able to get it built successfully, but when I tried printing the extruder motor would not push the filament through. I was able to track the issue back to the stepper motor driver by moving it to the x-axis slot. When testing it on the x-axis ...