Geeetech

hi yeah i finally fix it.... probable i did something wrong with the 1st set up cause i delete the repetier and load it again and works.. but only if i have it with my lap top connected if i do save to sd card and try to print it make every second auto home...... not sure why .... thank you for your...

[quote="stavros_gr"]hi again been busy so today i check the PSU and it gives 12v even when the retraction.. i also try to print the cube test you send me the link of...... and at 15% about 4 minutes it did it again it retract the filament after the retract i did an auto home but it not lose the poin...

hi again been busy so today i check the PSU and it gives 12v even when the retraction..
i also try to print the cube test you send me the link of...... and at 15% about 4 minutes it did it again it retract the filament
i add a pic hope you can see where it stopped
thank you in advance for your respond

hi again thank you for your help and your respond and i m really sorry to keep send it you (but i have not knowledge about any of this) ok i will look around to find a voltmeter to check as the link show ..... but just a question if that was a problem with no volt that should mean that the printer w...

hi again as i mention the printer is work correct all the axis are move the right way.... i even start print and start ok.... after a while is not working correct and i write to some other facebook page about 3d printer and some person told me that might be heating problem that the "motherboard" is ...

hi yeah as i mention the printing start ok.... and in move axis works everything as it should after it start printing makes that problem.... but yesterday i post a comment on facebook in a croup and some one reply to me and mention maybe the motor is over heat or the "motherboard" (where the motor i...

hi i have a Geeetech Acrylique Reprap Prusa I3 Pro B 3D imprimante 3D Printer MK8 i have an issue .... when i start print something... and the printer begins after 3 or 4 minutes of print (everything works ok) but then the motor of the extruder retract the filament and push it pass the gear and then...

hi i have a Geeetech Acrylique Reprap Prusa I3 Pro B 3D imprimante 3D Printer MK8 i have an issue .... when i start print something... and the printer begins after 3 or 4 minutes of print (everything works ok) but then the motor of the extruder retract the filament and push it pass the gear and then...