Geeetech

I went through an underpowered power supply, but not near the problems you've had. Good work getting that far! I'm at about the same point and it seems adjusting the bed with the screw and wingnut at the base doesn't work. =/ it might for you though. Also got the zstop for autoleveling use an induct...

Its a custom link on a popular stl file site, please contact the author there. Unsure of post rules concerning links to other sites, will pm you.

I was able to get the firmware uploaded and running, and communication established between repetier host and the printer. The error was only happeneing when I tried to initiate the motors from either the computer or the display on the printer. I ended up just using an instance of repetier firmware a...

I was unsure about it being a bad power supply as there was no response from the previous poster. I ended up grabbing one out of an old computer and getting it to run the printer (output amperage matched with the unit that came with the printer). Now it runs fine in standalone mode, the extruder and...

So, I began unplugging everything again in an attempt to help isolate the issue. I didn't think much of it earlier, but I don't know what the runs of the PCB look like. Could the image below cause a short in the board or something? It's the leads coming through the board from the power supply. http:...

The link you provided is broken into steps. Here are my results from each step. Step 1: Pass Step 2: Pass Step 3: 3.38V on either side of the fuse Step 4: 4.3V It's being under fed by a decent margin. It sounds like the fuse is bad maybe? EDIT: Just to be safe, the board is a GT2560 and I'm running ...

I might as well document progress in this thread. Troubleshooting today included: I checked the voltages according to http://www.geeetech.com/forum/download/file.php?id=1512 and they were all grossly under powered. Between 0.4 to 0.6V. I've adjusted them all to be right at 1.1V. I'm getting a little...

Can I get input from an admin or something? Did I put this in the wrong subforum? Is this forum not very active? Or am I just screwed? I sent in a ticket with technical support last night but havent received a response.

Hello all, I'm new to 3d printing and got my first printer for Christmas. I assembled it based on the instructions found in the wiki and am using the version of Marlin from the wiki as well. In the quick setup guide it starts by having the user level the bed with a... well level... by adjusting the ...