Search found 7 matches

by mihokopi
Tue Jan 17, 2017 6:35 pm
Forum: Control Board
Topic: Heater bed burnt out now gt2560 is stuck in endless bootloop
Replies: 2
Views: 1528

Re: Heater bed burnt out now gt2560 is stuck in endless boot

there is 3 1 second bursts of orange on the led between reboots on the control board.
by mihokopi
Tue Jan 17, 2017 4:42 pm
Forum: Control Board
Topic: Heater bed burnt out now gt2560 is stuck in endless bootloop
Replies: 2
Views: 1528

Heater bed burnt out now gt2560 is stuck in endless bootloop

The print bed, started smoking then burnt out refusing to light up, which caused the printer to reboot, which got it stuck in a loop where it reboots with everything powering up for 3-5 seconds then it resets and starts over. Tried to boot it without the print bed connected but it continues to reboo...
by mihokopi
Mon Jan 16, 2017 7:22 pm
Forum: Stepper Motor
Topic: motor works for a single print then burns out the wire
Replies: 3
Views: 2250

Re: motor works for a single print then burns out the wire

Found out what the problem was there was a short on the back of the control board, that lead to all the problems with it burning out stepper motors and wires.
by mihokopi
Thu Jan 12, 2017 5:31 pm
Forum: Stepper Motor
Topic: motor works for a single print then burns out the wire
Replies: 3
Views: 2250

motor works for a single print then burns out the wire

Recently, whenever i use the stepper motor on the extruder it will work for 1-3 prints, figuring it might just be the controller so i tried swaping it with one for another motor, the other motor worked, but extruder motor still refused to work. So i ended up replacing the cable worked great for 2 pr...
by mihokopi
Wed Dec 28, 2016 10:06 pm
Forum: Geeetech A20M
Topic: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer
Replies: 326
Views: 216158

Re: 3D Touch Sensor:Auto-levelling for Geeetech 3D printer

Hi does anyone else have the pin twitch from side to side when they use the M280 P0 S10 ; pushes the pin down.
Then when i try to use the M280 P0 S120 ; Self test, it just does an error til i reset it.

Any ideas what might be causing this
by mihokopi
Wed Dec 28, 2016 3:14 pm
Forum: Print Quality
Topic: having minor printer quality issues
Replies: 3
Views: 2741

Re: having minor printer quality issues

Some time the filament didnt come out at all while printing, othertimes its extruded but didnt stick instead picking up the previous layers creating a ball of filament on the noozle. The filament its been doing it with was 3d filaprint premium, rigid.ink and some super cheap chinese filament off eba...
by mihokopi
Tue Dec 27, 2016 5:42 am
Forum: Print Quality
Topic: having minor printer quality issues
Replies: 3
Views: 2741

having minor printer quality issues

Had the printer about a month, its a prusa i3 B since then ive had to replace the usb cable, all the screw rods were bent, ive tried 3 different brands of filament, and only the sample one ended up working. Since then i got a 3dtouch to help with bed leveling, just printing the holder didnt work wel...