Search found 3 matches

by jgs
Fri Dec 09, 2016 9:54 am
Forum: Others
Topic: 3DTouch
Replies: 4
Views: 3027

Re: 3DTouch

I tried the Teflon tape the pin is still not pushing down.
I borrowed a sensor from a friend to try and see if the problem was the sensor or printer.
With the new sensor it is working without any problems. so the problem must be with the sensor.
by jgs
Wed Dec 07, 2016 11:18 am
Forum: Others
Topic: 3DTouch
Replies: 4
Views: 3027

Re: 3DTouch

This is what I have tried so far: 1 Sent a M280 P0 S160 to release the alarm the LED stops flashing and stays on solid. 2 Adjusted the screw in the top counter clockwise till LED goes out adjusted the screw clockwise till the LED just comes on. 3 Sent a M280 P0 S10 the pin was in the up position. Th...
by jgs
Wed Dec 07, 2016 9:30 am
Forum: Others
Topic: 3DTouch
Replies: 4
Views: 3027

3DTouch

I installed the 3d touch sensor and setup firmware with no problems. started printing with no problem but on the third print I came back and the pin was laying on the table next to the printer. I then put the pin back in but it didn't seem to slide into anything. Now when I power it up it doesn't mo...