Search found 4 matches

by neoprogger
Wed Jan 04, 2017 3:57 am
Forum: Print Quality
Topic: G2s Pro Mini Calibration issues
Replies: 3
Views: 3101

Re: G2s Pro Mini Calibration issues

Hi,
Both nozzles are fixed and tight.
on X (X-43,3Y-2) and Z (X0 Y63)it is correct.
On Y (X43,3,Y-2) the front nozzle is always touching the plate.
I think either the rods/rod bearings/spider is strange..
by neoprogger
Sun Jan 01, 2017 6:09 am
Forum: Print Quality
Topic: G2s Pro Mini Calibration issues
Replies: 3
Views: 3101

G2s Pro Mini Calibration issues

Hi, I recently got the G2s Pro for Christmas. Assembly was fun and fast, but calibration is driving me insane: When adjusting X and Z Tower (with endstops) everything is ok. The rear nozzle touches the Plate and the front nozzle is ~1mm above (intended for testing). But on Y Tower, the front nozzle ...
by neoprogger
Wed Sep 21, 2016 9:33 pm
Forum: Control Board
Topic: MKS TMC2100 stepper motor driver
Replies: 4
Views: 4619

Re: MKS TMC2100 stepper motor driver

Update: Just replaced 3 of my Drivers.
in spreadCycle Mode they produce a lot of noise when powered with 12 volts.

The StealthChop works perfectly. Just remove all 3 jumpers and dont connect pin conf1-3.

Voltage is adjusted to 0,6V, works just fine.

Nearly noiseless running now.
by neoprogger
Mon Sep 19, 2016 2:40 pm
Forum: Control Board
Topic: MKS TMC2100 stepper motor driver
Replies: 4
Views: 4619

Re: MKS TMC2100 stepper motor driver

They are compatible.
Do I need to adjust any voltage?
According to http://blog.gummibaer-tech.de/tmc2100-s ... olu-a4988/
it is not needed.

Thanks !