Search found 123 matches

by Cup
Thu Mar 02, 2017 3:55 pm
Forum: Stepper Motor
Topic: Stepper motor only moves in one direction
Replies: 7
Views: 13410

Re: Stepper motor only moves in one direction

If you don't home the printer after you start it, all the axes will regard the original coordinates as the home position and will only go in one direction. :)
by Cup
Thu Mar 02, 2017 2:45 pm
Forum: Control Board
Topic: printer will not work properly
Replies: 4
Views: 6981

Re: printer will not work properly

hi,if it's actually quality problem,the after-sale will send you a new one... :D
by Cup
Fri Feb 24, 2017 4:55 pm
Forum: Stepper Motor
Topic: M201 printer - change steper motors for Z axe
Replies: 1
Views: 5368

Re: M201 printer - change steper motors for Z axe

Of course you can.
by Cup
Wed Jan 18, 2017 3:44 pm
Forum: Products FAQ
Topic: GT 2560 3pin modification for BL touch sensor
Replies: 7
Views: 20396

Re: GT 2560 3pin modification for BL touch sensor

Did you fix it?I guess it is the firmware issue.
by Cup
Wed Jan 18, 2017 3:33 pm
Forum: Products FAQ
Topic: Problems Prusa i3 Pro B
Replies: 4
Views: 9073

Re: Problems Prusa i3 Pro B

Congratulations.
by Cup
Wed Jan 18, 2017 3:31 pm
Forum: Products FAQ
Topic: geeetech i3 part cooling fan connection
Replies: 2
Views: 7304

Re: geeetech i3 part cooling fan connection

Fans 1/2/3 are common ones that have the solid speed,you need connect the fan to PWM_fan if you wanna control the speed.
by Cup
Wed Jan 18, 2017 3:26 pm
Forum: Products FAQ
Topic: Rostock 301 Extruder
Replies: 1
Views: 5110

Re: Rostock 301 Extruder

First make sure you can extrude the filament smoothly(though hard) with you hand.
If you can't make it successfully,the nozzle size may have a problem i guess.
Then you can set the nozzle diameter in Slicer Settings to 0.2 or 0.3mm to see if there is a difference.
by Cup
Wed Jan 18, 2017 3:21 pm
Forum: Products FAQ
Topic: GT2560 Rev A+ no voltage
Replies: 2
Views: 7150

Re: GT2560 Rev A+ no voltage

You need give the power to the board first if you are using RevA+...
by Cup
Wed Jan 18, 2017 3:18 pm
Forum: Products FAQ
Topic: Geeetech i3 ProB Y axis always triggered
Replies: 1
Views: 4840

Re: Geeetech i3 ProB Y axis always triggered

Maybe you can refer to this to modify the pin assignment of Y_min and Y_max to take a look:
viewtopic.php?f=20&t=18020
by Cup
Wed Jan 18, 2017 3:01 pm
Forum: Products FAQ
Topic: Problems Prusa i3 Pro B
Replies: 4
Views: 9073

Re: Problems Prusa i3 Pro B

Your Y axis has a layer shifting.
Check if the motor on Y axis was losing steps or the bearing on Y smooth rods is hard to move(spread some lubricating oil on them).
Additionally,check the belt on Y axis is too loose or too tight.