Search found 27 matches

by Fluxcore
Wed Apr 24, 2019 6:28 am
Forum: Geeetech I3 Pro W
Topic: Power Supply Issues
Replies: 4
Views: 685

Re: Power Supply Issues

Did you check the 220/115 ac switch ?
by Fluxcore
Sat Nov 04, 2017 1:23 pm
Forum: Feedback&Suggestion
Topic: Duplicator 5
Replies: 2
Views: 1787

Re: Duplicator 5

Thank you for the fun and quality product. Also the very good youtube instructions .
by Fluxcore
Wed Nov 01, 2017 10:20 pm
Forum: Feedback&Suggestion
Topic: Duplicator 5
Replies: 2
Views: 1787

Duplicator 5

100mm longer Z axis connection wire , or more clearance between build platform and back of printer . Longer bolts for build platform on the springs .
Better quality cooling fan to cool the control board , mine has to be replaced due to noisy bearing already .
by Fluxcore
Mon Oct 16, 2017 11:33 am
Forum: Feedback&Suggestion
Topic: Z-axis wireing in the duplicator 5
Replies: 3
Views: 1705

Re: Z-axis wireing in the duplicator 5

No,I am using jumper wires .
by Fluxcore
Thu Oct 12, 2017 4:03 am
Forum: Feedback&Suggestion
Topic: Z-axis wireing in the duplicator 5
Replies: 3
Views: 1705

Z-axis wireing in the duplicator 5

https://www.thingiverse.com/groups/geeetech-duplicator-5/topic:21748 Well this is a major screw-up , the wireing harness that goes to the Z-axis end stop is 10 cm to short . I have lots of breadboard jumpers so i just used 3 x 10cm ones I had on hand but not everyone has these . The build platform c...
by Fluxcore
Sat Oct 07, 2017 10:48 am
Forum: Mods And Hacks
Topic: Protect your Board .
Replies: 1
Views: 1808

Protect your Board .

A link to my Duplicator 5 build pics .

https://1drv.ms/f/s!ApuySntA2y3I90Algo7yb2pIfiM0
by Fluxcore
Fri May 13, 2016 11:36 pm
Forum: Firmware
Topic: X-axis problem Prusa I3
Replies: 10
Views: 9475

Re: X-axis problem Prusa I3

what kind of wiring are you using ? If you are using that Dupont connector type of connector on the end that could be the problem as there not very secure and if one contact is bad it could cause intermittent contact problems .
by Fluxcore
Sat May 07, 2016 12:04 pm
Forum: Firmware
Topic: Changing Thred rod
Replies: 3
Views: 2398

Re: Changing Thred rod

by Fluxcore
Sun Apr 24, 2016 5:20 am
Forum: Others
Topic: DRV8825 missing microsteps ? very interesting article
Replies: 0
Views: 1368

DRV8825 missing microsteps ? very interesting article

http://cabristor.blogspot.ca/2015/02/dr ... steps.html

And the results are impressive for such a easy installation .