Geeetech

Hi William. I have unmount an mount again the whole printer checking all alignments measures etc. I have been extremely careful in mounting. The printer seems to work a little smooth but the "cracks" are still there. May be I have won about 1 cm in diameter, being able to print pieces of 8 cm long i...

Hi William.

I have checked many times the alignment of the motors and the pulleys. Mysteriously, the belts and pulleys cracks much more when the belt it´s tight. However I will check and try again. I´ll report you as soon as I have tried.

Hi William. Could you please tell me if is someone in Spain who could help me with the printer. I´m still trying to calibrate the printer an trying to print things like the PSU case. It´s absolutely impossible print pieces bigger than 5 or 6 cm diameter. The printer loose head position and the pulle...

Just two months waiting for any helming. Pleaseeeeee HEEELLLLLPPPP!!!!!!

PSU case printing

https://youtu.be/Syv0hOKo8WA

I have adjust the voltage of the drivers to 1 volt and I have noticed a little improve but the cracks of the pulleys still are there. I'm sending a new video trying to print PSU case.
At least now I can print little pieces without problems but the quality is quite poor. See the attached photo.

Thank You very much.

I am using lithium grease to on the rails and bearing. It goes super smooth.
I will measure the voltage and adjust it this weekend.

Videos uploaded to Youtube.
1- https://youtu.be/ta5m9hF4wXQ
2- https://youtu.be/CHKrmIe_qbA

Hello
Those are the videos
1- Autoleveling. Ear the "cracks" of the pulleys
2 Triying to print PSU case from thingiverse

Thank You.

I am sorry but I have tried to upload the videos on AVI, MPEG, M4V, MOV formats and always get the message "The extension XXX is not allowed

Of course, tonight I'll upload video.