3D printing trouble shooting guide

New Multi-color 3D Printers Mizar M is Officially Launched, With Double Hotend Group Modules

By Geeetech
04/11/2022

On October 28th CST, Geeetech released a new generation mixing color 3D printer, Mizar M. Compared to Geeetech’s previous multi-color 3D printers, Mizar M is equipped with two print head modules – “Separated Color Module” and “Gradient Color Module”, corresponding to the two printing modes of “Separate Mode” and “Gradient Mode” respectively, allowing 3D printer enthusiasts to enjoy multi-color printing. At present,…

5 Easy Ways to Prevent 3D Print Stringing

By Geeetech
08/10/2020

Stringing is one of the common issues we would meet during printing. Here are 5 solutions that you can refer to. Without a doubt, you can’t bear some minor flaws in the surface of a 3d printing model, let alone “String”. You complained that this printer is such trash contrary to expectations. At that time, you may get mad but it will eventually…

3D Printer Filament Storage – How Is It Done Properly?

By Geeetech
24/09/2020

If you have moisture and mold in your home, you’re more likely to have respiratory problems, allergies, and weak immune system. When you know the cause of the moisture, you can take steps to limit the moisture in the air. Likewise, humidity is a natural enemy of filaments. Some materials have no humidity problem. Others, such…

How to Prevent Blobs?Tips to Get Your Girl Back

By Geeetech
18/09/2020

I dated a girl to count stars over the lake last night.She is so beautiful and a perfectionist to her fingertips.A few months ago,I followed her instagram account and found that she loves Pokemon toys very much.So I decided to make a Charizard with a 3D printer and gave her as a gift.She looked at this cute stuff carefully but soon…

Tips on How to Improve 3D Print Quality

By Geeetech
31/07/2020

3D printing can present all sorts of problems. Whether you are a newbie or an expert, chances are you are constantly tweaking a bit here and a bit there just to get the desired results. There are, however, a number of things you can do to get around some common issues in 3D printing and…

Trouble Shooting: How to Reduce Stringing

By Geeetech
28/07/2020

In FDM 3D printing, sometimes the nozzle may deposit unwanted plastic on the printed part where it is not supposed to while the extruder is traveling to a new point; the plastic then cools and sticks to the object, making it look hairy and unsightly. 3D printing stringing can be a common problem especially if…

What is Layer Shifting and How to Fix it?

By Geeetech
22/07/2020

Layer shifting, in other words, known as layer misalignment, is when the layers of the print are not properly aligned, and the print can be unsightly(mostly a failure). It is a common issue in 3D printing and can be tricky, especially if you are a newbie. This article will walk you through the possible causes…

Plastic Not Sticking To the Bed

By Geeetech
22/07/2020

When the first layer is not staying flat on the print bed, check whether the bed is level. An unlevel bed would cause the object to warp and/or cracks in the higher layers of the object. Leveling can be tedious and time-consuming, but it’s well worth the effort(If you hate this you can always choose…