Relatives
.jpg "Iduino LilyPad 328 Main Board")
Recently Viewed
This is a high performance DC Power Step Down Adjustable Supply Module
Design based on the well known LM2596 Switching Regulator.
- Input voltage: 4.5-35V
- Output Voltage: 1.25-30V (adjustable)
- Output current: rated current 2A, maximum 3A. A heat sink is need, if the output power greater than 15W, the proposed combined heat sink
- Conversion efficiency: Up to 92% (output voltage higher, the higher the efficiency)
- Switching Frequency: 150KHz
- Rectifier: Non-Synchronous Rectification
- Module Properties: Non-isolated step-down module (buck)
- Short circuit protection: current limiting, since the recovery
- Operating temperature: Industrial grade (-40 ℃to +85 ℃) (output power 10W or less)
- Full load temperature rise: 40 ℃
- Load regulation: ± 0.5%
- Voltage regulation: ± 0.5%
- Dynamic response speed: 5% 200uS
- Size: 49 (L) * 23.5 (W) * 12.5 (H) mm (with potentiometer)
Package list
10 x DC Power Step Down Adjustable Supply Module
- Payment
- Shipment
- Taxes And Tariffs
- After sale service
- Blog
- Download EasyPrint 3D APP
TERMS OF USE
- About Us
- Contact Us
- Home Page
- Site Map
-
COMPANY INFORMATION
© 2020 GETECH, All Rights Reserved.
TOP
I only need 2, is there a way to just get 2 of these?
It's ok, please read the info carefully next when place order. Thanks, Regards
I did not read the description carefully. There other boards that look like this and use the LM2596 chip that will boost the voltage. This is not one of them. This one will deliver about 0.2v less than the supply voltage at the highest. So it functions as a VR without the usual 1.5v overhead requirement. Unfortunately, that is not what I thought I was buying. My fault.