Difference between revisions of "Real Time Clock RTC DS1307 Module"
(→PIN DESCRIPTION) |
(→PIN DESCRIPTION) |
||
| Line 30: | Line 30: | ||
SDA - Serial Data | SDA - Serial Data | ||
| + | SDA is the input/output pin for the 2-wire serial interface. The SDA pin is open drain which requires an external pullup resistor. | ||
| − | SCL - Serial Clock | + | SCL - Serial Clock |
| + | SCL is used to synchronize data movement on the serial interface. | ||
| − | SQW/OUT | + | SQW/OUT (Square Wave/Output Driver) – When enabled, the SQWE bit set to 1, the SQW/OUT pin |
| + | outputs one of four square wave frequencies (1Hz, 4kHz, 8kHz, 32kHz). The SQW/OUT pin is open | ||
| + | drain and requires an external pull-up resistor. SQW/OUT will operate with either Vcc or Vbat applied. | ||
| + | |||
| + | X1, X2 – Connections for a standard 32.768kHz quartz crystal. The internal oscillator circuitry is | ||
| + | designed for operation with a crystal having a specified load capacitance (CL) of 12.5pF. | ||
Revision as of 06:58, 4 May 2012
DESCRIPTION
The DS1307 Serial Real-Time Clock is a low-power, full binary-coded decimal (BCD) clock/calendar plus 56 bytes of NV SRAM. Address and data are transferred serially via a 2-wire, bi-directional bus. The clock/calendar provides seconds, minutes, hours, day, date, month, and year information. The end of the month date is automatically adjusted for months with fewer than 31 days, including corrections for leap year. The clock operates in either the 24-hour or 12-hour format with AM/PM indicator. The DS1307 has a built-in power sense circuit that detects power failures and automatically switches to the battery supply.
FEATURES
- Real-time clock (RTC) counts seconds,minutes, hours, date of the month, month, daof the week, and year with leap-year compensation valid up to 2100
- 56-byte, battery-backed, nonvolatile (NV) RAM for data storage
- Two-wire serial interface
- Programmable squarewave output signal
- Automatic power-fail detect and switch circuitry
- Consumes less than 500nA in battery backup mode with oscillator running
- Optional industrial temperature range:-40°C to +85°C
- Available in 8-pin DIP or SOIC Underwriters Laboratory (UL) recognized
PIN DESCRIPTION
VCC - Primary Power Supply
X1, X2 - 32.768kHz Crystal Connection
Vbat - +3V Battery Input
GND - Ground
SDA - Serial Data SDA is the input/output pin for the 2-wire serial interface. The SDA pin is open drain which requires an external pullup resistor.
SCL - Serial Clock SCL is used to synchronize data movement on the serial interface.
SQW/OUT (Square Wave/Output Driver) – When enabled, the SQWE bit set to 1, the SQW/OUT pin outputs one of four square wave frequencies (1Hz, 4kHz, 8kHz, 32kHz). The SQW/OUT pin is open drain and requires an external pull-up resistor. SQW/OUT will operate with either Vcc or Vbat applied.
X1, X2 – Connections for a standard 32.768kHz quartz crystal. The internal oscillator circuitry is designed for operation with a crystal having a specified load capacitance (CL) of 12.5pF.
