Difference between revisions of "PIR motion sensor Module"

From Geeetech Wiki
Jump to: navigation, search
(Technical parameters)
Line 20: Line 20:
 
[[File:PIR sensor wiring.jpg]]
 
[[File:PIR sensor wiring.jpg]]
  
==Example code==
+
===Example code===
 
  int pirPin = 2; //digital 2
 
  int pirPin = 2; //digital 2
 
  void setup(){
 
  void setup(){
Line 36: Line 36:
 
   }
 
   }
 
  }
 
  }
 +
=== Adjustment ===
 +
[[File:PIR sensor2.jpg]]
 +
 +
[[File:PIR sensor1.jpg]]

Revision as of 09:32, 7 May 2012

Introduction

PIR1.jpg

PIR2.jpg

PIR sensors allow you to sense motion, almost always used to detect whether a human has moved in or out of the sensors range. They are small, inexpensive, low-power, easy to use and don't wear out.PIR sensor are basically made of a pyroelectric sensor (which you can see above as the round metal can with a rectangular crystal in the center), which can detect levels of infrared radiation. Everything emits some low level radiation, and the hotter something is, the more radiation is emitted. The sensor in a motion detector is actually split in two halves. The reason for that is that we are looking to detect motion (change) not average IR levels. The two halves are wired up so that they cancel each other out. If one half sees more or less IR radiation than the other, the output will swing high or low.

Technical parameters

  • Operating voltage: DC5V to 20V
  • Static power consumption: 65 microamps
  • level output: high-5V, low-0V
  • Delay Time: adjustable (0.3 seconds to 18 seconds)
  • embargo time: 0.2 seconds
  • sensing range: less than 120 degrees angle, 7 meters
  • Operating temperature: -15 ~ +70 degrees

Usage

PIR sensor3.jpg PIR sensor wiring.jpg

Example code

int pirPin = 2; //digital 2
void setup(){
pinMode(pirPin, INPUT);
pinMode(13, INPUT);
}
void loop(){
 int pirVal = digitalRead(pirPin);
 if(pirVal == HIGH)
 { //was motion detected
 digitalWrite(13,HIGH);
 delay(500);
 digitalWrite(13,LOW);
 delay(500);
 }
}

Adjustment

PIR sensor2.jpg

PIR sensor1.jpg