Difference between revisions of "IMU Digital Combo Board-6DOF ADXL345 and ITG3205"
From Geeetech Wiki
(→Document) |
|||
| Line 13: | Line 13: | ||
==Document== | ==Document== | ||
| − | [http://www.geeetech.com/Documents/ADXL345%20Datasheet.pdf ADXL345 accelerometer datasheet] | + | [http://www.geeetech.com/Documents/ADXL345%20Datasheet.pdf ADXL345 accelerometer datasheet][br] |
[http://www.geeetech.com/Documents/ITG-3205-00-01.4.pdf ITG3205 Gyro datasheet] | [http://www.geeetech.com/Documents/ITG-3205-00-01.4.pdf ITG3205 Gyro datasheet] | ||
Revision as of 07:06, 29 May 2012
Introduction
This product is a simple breakout for the ADXL345 accelerometer and the ITG-3205 gyro. You get a full 6 degrees of freedom With this board. The sensors communicate over I2C and one INT output pin from each sensor is broken out. If you need a simple and tiny board that gives you 6 degrees of freedom, this would be a good choice.
Features
- Tiny
- ADXL345 accelerometer
- ITG-3205 gyro
- 3.3V input
- 2C interface
Document
ADXL345 accelerometer datasheet[br] ITG3205 Gyro datasheet
Usage
Here is a guide illustrates how to connect an IMU 6DOF board to Arduino. The following is a table describe which pins on the Arduino should be connected to the IMU 6DOF board.
VCC -> 3.3V GND -> GND SDA -> A4 SCL -> A5
Example code
IMU 6 DOF Combo Board Example code
How to buy
Click here to buy IMU Digital Combo Board-6DOF ADXL345 and ITG3205
