Difference between revisions of "GT2560A/GT2560A+"

From Geeetech Wiki
Jump to: navigation, search
(Features)
(Introduction)
Line 1: Line 1:
==Features==
+
==Introduction==
  
1.Integrated with the mighty function of the Arduino Mega2560+Ultimaker and Arduino
+
GT2560 is a compact board that is integrated with the mighty function of the Arduino Mega25
Mega2560+ramps 1.4 kit, The GT2560 can not only take full place the them on respect of both
+
60+Ultimaker and Arduino Mega2560+ramps 1.4 on respect of both software and hardware and has
software and hardware, but also features compact size, more convenient connection, and more
+
more premium features: the streamlined interfaces effectively avoid the unnecessary troubles, wellregulated
stable.
+
compaction of components highly integrated saves more space and easier to be mounted o
2. Adopt ATmega2560 as the main control chip, coupled with the high-performance USB serial
+
n most applications.
converter FT232RQ.
+
5 stepper motors, swappable driving modules, mighty ATmega2560 processor with 256k mem
3. The power pack: operating voltage is 12V-24V; double power supply design feeds for
+
ory, 16MHz operating frequency, high-performance USB serial converter FT232RQ, all these make
heatbed and logical part separately. The current is 15A for heatbed and 10A for other parts.
+
the GT2560 an ideal option for a 3D printer control board. What’s more, GT2560 can run over 12V
4. The main circuit adopts SMD fuse tube, the diode added to the power port can provide
+
to 24V which gives higher torque and higher rotation rate.
reverse protection to the whole circuit, in addition, the 5V USB is USB port protected with 500mA
+
Recoverable fuse.
+
5. 3 12v fan output and one PWM output for LED or other lighting equipment.
+
GEEETECH
+
www.geeetech.com Tel: +86 755 2658 4110 Fax: +86 755 2658 4074 -858
+
- 4 -
+
6. 3 55Amp MOSFET (with LED indicator, the actual output is restricted by the PCB board
+
and the connector), all 3 MOSFET are equipped with heat sink to ensure sufficient heat dissipation
+
and stable operation.
+
7. Support 5 A4988 stepper drivers (3 for X/Y/Z axis, and 2 for extruders); the subdivision of
+
stepper motor can be setup by dial switch, eliminating jumper caps, easier to operate.
+
8. 3 temperature sensor input (100k thermistor is recommended)
+
9. Extended LCD and SD card interface support both LCD2004 and LCD 12864, with which
+
you can print without your PC.
+
10. The firmware is the prevalent Marlin, which is known for stability, usability, and
+
high-performance.
+

Revision as of 10:41, 4 May 2018

Introduction

GT2560 is a compact board that is integrated with the mighty function of the Arduino Mega25 60+Ultimaker and Arduino Mega2560+ramps 1.4 on respect of both software and hardware and has more premium features: the streamlined interfaces effectively avoid the unnecessary troubles, wellregulated compaction of components highly integrated saves more space and easier to be mounted o n most applications. 5 stepper motors, swappable driving modules, mighty ATmega2560 processor with 256k mem ory, 16MHz operating frequency, high-performance USB serial converter FT232RQ, all these make the GT2560 an ideal option for a 3D printer control board. What’s more, GT2560 can run over 12V to 24V which gives higher torque and higher rotation rate.