X
.jpg)
if you are going to use the superplate glass to replace the black mylar sticker, one tip need your attention please, in case of the nozzle touch and scrach the platform:
Because the superplate glass is 3mm thicker than mylar sticker, After you replace the glass with existing mylar sticker,
pls remember to up the limit switch on Z axis for about 3mm, then do leveling before you start printing and you can also slightly adjust the knob under platform.
We choose silicon carbide glass with microporous coating as the building platform for 3D printer, without the need of attaching the masking tape.
The silicon carbide glass is of chemical stability, high heat conductivity coefficient and good wear-resistance and can withstand extreme temperature. The special coating is inorganic and has a hardness of 8 Mohs, hence of high durability.
Compared with common building platform, this kind of tempered glass is of better adhesion and flatness and easy to take prints off. Besides, it is easy to clean with water or alcohol. Geeetech Superplate silicon carbide glass platform is regarded as a reliable building platform by 3D printing hobbyists.
Features:
Better adhesion: Superplate is coated with micropores, having strong adhesion during printing.
High-performance: The silicon carbide glass is of chemical stability, high heat conductivity coefficient and good wear-resistance and can withstand extreme temperature.
Reliability: The special coating is inorganic, with its hardness of 8 Mohs and heat resistance up to 400 ℃.
Easy to clean with water or alcohol.
Easy to remove your print by hand without the help of scraper.
TOP
Can double sided tape be used to fix the plate?
hello , it will be better to use clips to fix it , so you can remove it from heatbed when it get broken or need replaced.
Does the home switch need to be moved if using the auto bed leveling sensor
yes, if you use 3d touch auto leveling sensor , pls remove off the Z axis limit switch/endstop
Can I also use this Superplate on my A10T?
hello, yes, it can also be used on your A10T
Do i need specific things to replace mylar with a Superplate on my A10 ?
hello, just use several clips to fix the glass platform is ok.
"pls remember to up the limit switch on Z axis for about 3mm" can you give me some details on this - it does sound like I pysicall move the z limited up a bit - to get the print head close to the glass surface?
hi, yes, it means pysically move the z limit switch for about 3mm if you are going to use the superplate glass to replace the black mylar sticker, because the superplate glass is 3mm thicker than mylar sticker
Hello, What are the size of Superplate Glass Platform. Is it really better than mylar ? regards
hello, yes, i am sure it is for A10 and A10M printer.
Are you sure it is for A10? The bed size of A10 is 220x200 and not 235x235
hello, this is for A10/A10M printer, 235mm*235mm*4mm. it depends, some customer prefer glass platform. some likes mylar sticker