Z axis won't go up

Post Reply
drtdray
Posts: 1
Joined: Sat Jun 08, 2019 9:20 am

Z axis won't go up

Post by drtdray » Sat Jun 08, 2019 9:29 am

So I had quite a bit of problems with the printer, but I solved most of them except this one I can't figure out. I start a test print and everything looked fine until the extruder wasn't able to lift up any higher and remained at the same level.

I can get my z axis to home just fine, there is no issue with both motors lowering the axis. However the z motor on the left side doesn't do anything when I try to move it upward. The right z motor turns on and lifts the axis a little bit, but then stops and starts to grind because the other motor isn't doing anything.

Any ideas?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Z axis won't go up

Post by William » Sun Jun 09, 2019 9:32 am

Hi, You can 1. Check if the left and right axes are at the same height;
2. Check if the left and right shafts are bent;
3. Detect the driving board voltage (0.8-1.2V);
4. Is the screwed brass nut too tight? It can be adjusted and then tightened.
I hope these can help you.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Lucas_0212
Posts: 1
Joined: Mon Jul 01, 2019 1:54 am

Re: Z axis won't go up

Post by Lucas_0212 » Mon Jul 01, 2019 2:22 am

I have the same problem, how do fix it?

Post Reply