How to configure github source to compile for a specific printer ?

Post Reply
entretoize
Posts: 9
Joined: Wed Feb 06, 2019 9:18 pm

How to configure github source to compile for a specific printer ?

Post by entretoize » Wed Feb 20, 2019 5:18 pm

Hello, I donwloaded some sources for my printer and be able to compile and upload them to it but how to start from the Marlin github code and make it compatible with a specific printer ?

Thanks

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: How to configure github source to compile for a specific printer ?

Post by William » Thu Feb 21, 2019 2:44 pm

What do you mean?
You need to refer to the video on :
how to change the fw for your printer, then you can know the steps of it.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

entretoize
Posts: 9
Joined: Wed Feb 06, 2019 9:18 pm

Re: How to configure github source to compile for a specific printer ?

Post by entretoize » Fri Feb 22, 2019 5:05 am

Video ?
I mean if you take the source from github, compile, and upload to your printer it won't work because some files need to be modified.
So if there's an update on github you can't get it for your printer, you need to wait geeetech to create the firmware.
If there's a procedure, anybody can to it himself...

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: How to configure github source to compile for a specific printer ?

Post by William » Mon Feb 25, 2019 9:13 am

entretoize wrote:
Fri Feb 22, 2019 5:05 am
Video ?
I mean if you take the source from github, compile, and upload to your printer it won't work because some files need to be modified.
So if there's an update on github you can't get it for your printer, you need to wait geeetech to create the firmware.
If there's a procedure, anybody can to it himself...
There are two ways to modify the firmware:
The first is to use avr and the other is to use source insight
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 57 guests