
Functions:
- Language english
- manual Bed Leveling over 9 Points activated
- automatic Z adjustment at printing
A10 Firmware on Thingiverse
Using without any warranty an on your own risk!
Moderator: vert
If you need to change any functions into Marlin you need to use the arduino ide to do it.zonalimitatore wrote: ↑Tue Aug 28, 2018 7:16 amHello everyone...
This firm it's ready for install o i need edit config in arduino ide?
Or simply click on marlin.ino and upload on board?
Danke.MichaelK wrote: ↑Tue Aug 28, 2018 12:19 pmIf you need to change any functions into Marlin you need to use the arduino ide to do it.zonalimitatore wrote: ↑Tue Aug 28, 2018 7:16 amHello everyone...
This firm it's ready for install o i need edit config in arduino ide?
Or simply click on marlin.ino and upload on board?
You can use many ways to install the firmware.
two possebilities:
1: Arduino IDE, conect the printer with Pc, start arduino with the marlin.ino and save them onto the printer directly.
2: use xloader http://russemotto.com/xloader/ to install the .hex File onto the printer.
I think, the second way is easier....