hi guys
i bought a Acrylic Geeetech Prusa I3 pro B 3D Printer DIY kit and build it without any problem. But when i was going to print for the first time came the MINTEMP ERROR at the LCD Display. I saw on internet about but didnt find any solution. My printer has 1 extruder but the board has 2 thermistor entrances, so i just connected the wire in one. Could it be the problem ? Does it means that the circuit is open ?
Whats the solution ?
I attached a photo of the infos from my lcd display
Thanks a lot!!!
https://scontent.fopo1-1.fna.fbcdn.net/ ... e=58ADC170
MINTEMP ERROR AT FIRST TRY
Re: MINTEMP ERROR AT FIRST TRY
Make sure you have the two thermistor cables correctly connected:
-
- Posts: 4
- Joined: Tue Feb 21, 2017 7:19 am
Re: MINTEMP ERROR AT FIRST TRY
Yes, i do. but it continues with the same error.
but thanks for the reply
but thanks for the reply
Re: MINTEMP ERROR AT FIRST TRY
It shouldn't be like that...
You can refer to this post to check your sockets on the board:
viewtopic.php?f=23&t=17030
You can refer to this post to check your sockets on the board:
viewtopic.php?f=23&t=17030