Set the slicer feed rates to almost absurd values, like 1 and 2 Then the result in the generated gcode is between acceptable ranges. If this work, I will try to modify the firmware feedrate calculation simplifying the formula and splitting it in more parts.
As I have finished the test cycles I will post an update anyway.
Now setting these low values the printer moves. Not fine because the values are too low in some cases but the problem on the z-axis occurs only when there is normal feedrates set in the slic3r with the Repetier host (take in account that I have saved the various kind of slic3r settings.
Exploring the firmware Medel_main.cpp it seems that for some strange reason the feedrate forumla
Code: Select all
Hope you can suggest something else...
Thank you. Enrico
- Posts: 46
- Joined: Mon Apr 04, 2016 8:42 pm
- Location: MONA TILES COMPOUND, NR. CHHANI CIRCLE, CHHANI ROAD, VADODARA - 390002. GUJARAT, INDIA.
M500 then saves the current settings to eeprom which are then loaded at power-up or reset. 3d printing service visakhapatnam kochi india
I had a problem once when my printer started doing strange things after firmware update and this fixed it. It was because the new firmware stored config settings in different locations in eeprom.
visit:3d printing service india
Who is online
Users browsing this forum: No registered users and 0 guests