Multi Color Printing Problem

Post Reply
rmrodrigues
Posts: 42
Joined: Wed Oct 14, 2015 5:37 am

Multi Color Printing Problem

Post by rmrodrigues » Thu Nov 19, 2015 4:35 pm

Hi There,
I'm trying to print a key holder example made by me but the second extruder is printing out of the correct location.

Please see the attached photo.
Image

When I use Slic3r the extruder print at same time and side by side. This gcode was generated with CURA and the result is above.

Any suggestion?

Best,
RMRodrigues.

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Multi Color Printing Problem

Post by Mark » Thu Nov 19, 2015 5:46 pm

the photo is broken...

rmrodrigues
Posts: 42
Joined: Wed Oct 14, 2015 5:37 am

Re: Multi Color Printing Problem

Post by rmrodrigues » Thu Nov 19, 2015 5:51 pm

Here is it:

Image

Thanks Mark.

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Multi Color Printing Problem

Post by Mark » Thu Nov 19, 2015 6:06 pm

oh I see you use cura, sorry I haven't used it before...

rmrodrigues
Posts: 42
Joined: Wed Oct 14, 2015 5:37 am

Re: Multi Color Printing Problem

Post by rmrodrigues » Thu Nov 19, 2015 6:08 pm

Hi Mark,
I've used CURA as an alternative to Slic3r.
There is a guide to do that on Slic3r?

Thanks.

rmrodrigues
Posts: 42
Joined: Wed Oct 14, 2015 5:37 am

Re: Multi Color Printing Problem

Post by rmrodrigues » Fri Nov 20, 2015 5:17 am

Mark I think that my problem is due to a bad offset. What you think about that?

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Multi Color Printing Problem

Post by Mark » Fri Nov 20, 2015 3:45 pm

I think you can refer to this link to check the settings:
http://www.geeetech.com/wiki/index.php/ ... _extruders

Post Reply