Hi
Can you please send me the firmware for the Prusi I3 X with the single motherboard GT2560 . The board you sent with my order does not recognise the display , flashed new Marlin firmware however the printer is not working correctly , eg does not respond to the limit switch activation
Thanks
Firmware request GT2560
Re: Firmware request GT2560
hi, standard configration of the Prusa I3 X is sanguinalolu mainboard.by the way ,is the extruder single or dual,i will send you coresponding firmware.afanez wrote:Hi
Can you please send me the firmware for the Prusi I3 X with the single motherboard GT2560 . The board you sent with my order does not recognise the display , flashed new Marlin firmware however the printer is not working correctly , eg does not respond to the limit switch activation
Thanks
Re: Firmware request GT2560
The model printer is the Geeetech Prusa I3 X 3D printer with a single extruder - The main board is the white GT2560 board
Re: Firmware request GT2560
hi,i'v sent it to your mailbox.afanez wrote:The model printer is the Geeetech Prusa I3 X 3D printer with a single extruder - The main board is the white GT2560 board
Re: Firmware request GT2560
hi,sirmt.I've already sent it to you,please check your mailbox.
Re: Firmware request GT2560
Please send me correct firmware for my rostock g2s mini > Extruder 1& 2 do not work . trouble with x stepper motor. some times end stops seem not to work....help. asap. want to get this working asap
Re: Firmware request GT2560
please tell me the mainboard of your printer,I'll send the corresponding firmware to your mailbox.UNREAD_POST由 jamest » 周四 8月 06, 2015 5:00 pm
Please send me correct firmware for my rostock g2s mini > Extruder 1& 2 do not work . trouble with x stepper motor. some times end stops seem not to work....help. asap. want to get this working asap
jamest
帖子: 1
注册: 周四 8月 06, 2015 4:57 pm
Re: Firmware request GT2560
gt2560 g2s mini rostock...
Re: Firmware request GT2560
ooo....sorry!
I've sent it to your mailbox ,please check it!
I've sent it to your mailbox ,please check it!