Jerk in Z axis

Post Reply
shiva
Posts: 48
Joined: Sat Jun 13, 2015 2:51 am

Jerk in Z axis

Post by shiva » Mon Jul 27, 2015 4:53 pm

Hi
I am using Geeetech Dual Extruder Prusa i3 pro C kit.
Both Stepper motors (Z axis) turning little bit different speed.left side 2rounds bellow than right side.
Again if i adjust the both are same level,after some time (if machine run approximate 30 minuets) it goes to different level.I tightly screwed the Z Axis Couplers.still the jerk will come
Top
shiva
Posts: 48
Joined: Sat Jun 13, 2015 2:51 am

Re: Jerk in Z axis

Post by shiva » Wed Jul 29, 2015 8:27 pm

Can you sallow my problem?
Top
shiva
Posts: 48
Joined: Sat Jun 13, 2015 2:51 am

Re: Jerk in Z axis

Post by shiva » Mon Aug 03, 2015 3:43 pm

Please give me solution for this problem
Top
Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Jerk in Z axis

Post by Sherry » Mon Aug 03, 2015 4:15 pm

hello,shiva.your z axis appears to not move smothly.you can try to adjust those screws of 2 z-axis.it seems that the z axises are getting a little stuck.
Top
Post Reply

Return to “Stepper Motor”