Motors moving only to home

Post Reply
1inv
Posts: 2
Joined: Mon Mar 16, 2015 11:04 pm

Motors moving only to home

Post by 1inv » Tue Jul 07, 2015 9:12 pm

Board RUMBA with DRV8825 for printer Leapfrog Creatr.
All axises goes only to home (do not move + / - ) in manual control.
What must I do?

User avatar
Admin
Posts: 267
Joined: Wed Nov 30, 2011 9:49 am

Re: Motors moving only to home

Post by Admin » Wed Jul 08, 2015 10:22 am

Could you take a photo of LCD.i 'd like to see what LCD shows.

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Motors moving only to home

Post by Sherry » Wed Jul 08, 2015 10:51 am

hi,do LCD panel display any error such as MINTEMP error or MAXTEMP error?please do the following steps.
1.Click "emergency stop" in the repetier-host.
2.Reconnect the wire to controlboard.please plug the wire to into the slot firmly.
3.Restart the printer.

1inv
Posts: 2
Joined: Mon Mar 16, 2015 11:04 pm

Re: Motors moving only to home

Post by 1inv » Wed Jul 08, 2015 3:51 pm

My printer does not have an LCD display. Currently, board removed from the printer. I'm trying to run it, just by connecting the stepper motor and mechanical endstop.

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests