How to improve the surface condition of the print?

Post Reply
Laluuh
Posts: 11
Joined: Sun Jun 14, 2015 2:27 am

How to improve the surface condition of the print?

Post by Laluuh » Tue Jul 07, 2015 7:17 pm

Everything is in the title,
The first print was good, but since it's not terrible, printing are twisted. etc ..
How to improve all this? thank you

Good print (first print) :
http://image.noelshack.com/fichiers/201 ... -print.jpg

Bad print (now) :
http://image.noelshack.com/fichiers/201 ... rint-1.jpg
http://image.noelshack.com/fichiers/201 ... rint-2.jpg
http://image.noelshack.com/fichiers/201 ... rint-3.jpg
http://image.noelshack.com/fichiers/201 ... rint-4.jpg

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: How to improve the surface condition of the print?

Post by Sherry » Wed Jul 08, 2015 11:41 am

hi,please do the following steps.
1.Tight coupling shown in the picture.
2.the hot bed is out of level,please do the auto leveling .

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: How to improve the surface condition of the print?

Post by Sherry » Wed Jul 08, 2015 11:44 am

coupling
Attachments
QQ图片20150708113227.jpg
coupling
QQ图片20150708113227.jpg (120.66 KiB) Viewed 2435 times

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests