7 posts • Page 1 of 1
1)The X, Y and z axis do not work on (-) they only go forward (+), 2) the extruder goes up 4 mm when starting printing separating from the bed, 3)After doing the configuration on Slicer, when I start the printing, the extruder goes to the right(+) and tries to go out of the bed making the belt run, when I look at the position on the X and Y axis it is like 1400 both ways even do the bed is only 200 x 200, I did check all the settings, what am I missing? Help please!!!!
Could you take some photos and let me check.Or please refer to the link(step 6).furniturecreations wrote:Hi, the connection prongs for the end stops are 3, Sig, (+) and Gnd., I do have all of them on their respective (+) and Gnd. Is that correct?
link: http://www.geeetech.com/wiki/index.php/ ... tion#Step6
These are the pictures of the end stops and the connections on the Sanguinololu board
- 20150706_204253b.jpg (102.35 KiB) Viewed 4937 times
- 20150706_204312b.jpg (116.81 KiB) Viewed 4937 times
- 20150706_204241b.jpg (135.61 KiB) Viewed 4937 times
- 20150706_204340b.jpg (161.73 KiB) Viewed 4937 times
Who is online
Users browsing this forum: No registered users and 2 guests