A30M Poor Colour Mixing

Post Reply
Posts: 9
Joined: Wed Nov 27, 2019 3:11 am

A30M Poor Colour Mixing

Post by Deadeye » Sun Jan 19, 2020 8:29 pm

I found when i printed with two colours simultaneously (I was using 50% black and white, hoping to get grey) I found it wasn’t mixing very well. On the nozzle side the black was coming in it was black and on the other side where the white was coming in it was white; It was grey between them. How to get them the filiments mix properly?
94EFC323-6985-4B0F-B745-453AFAE39AC9.jpeg (424.8 KiB) Viewed 769 times

User avatar
Site Admin
Posts: 6032
Joined: Tue Jun 07, 2016 9:38 am

Re: A30M Poor Colour Mixing

Post by William » Mon Jan 20, 2020 9:37 am

Hi, Black supplies may have higher temperature requirements.
You can try increasing the temperature by 5-10.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Posts: 184
Joined: Sat Jan 26, 2019 8:42 am

Re: A30M Poor Colour Mixing

Post by Jarda3d » Tue Jan 21, 2020 7:44 am

Black need lower temp, white higher. But mixing is possible. Stringing is terrible....

The mixing coulours what you find is FEATURE of mixer hotend. Solution to have smooth colours is possible (look at my messages here, described few weeks ago), but chinese sellers sell me steel nozzles instead of brass what I want. Geee did not have MK10 nozzles with 4mm cave.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests