One of my extruders (number 3) is extremly noisy. It does make a sound, almost like a tune, varrying depending on the percentage applied to it.
Does someone have an idea about how this could be fixed/improved ?
'Singing' (and noisy) extruder
Re: 'Singing' (and noisy) extruder
Hi,Can you hear where the sound comes from?
A cooling fan on the motherboard voice?
If you can reduce the sound, you can try to replace it with a silent driver board.
A cooling fan on the motherboard voice?
If you can reduce the sound, you can try to replace it with a silent driver board.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: 'Singing' (and noisy) extruder
The noise comes from the extruder driver. The printer has one month and printed very few ;/ That said it seems working, just very noisy.
Re: 'Singing' (and noisy) extruder
Hi, Is your driver board red A4988?
It does n’t have a mute function.
It does n’t have a mute function.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: 'Singing' (and noisy) extruder
I think that it could be mechanical reason - did you tighten your printer?
Mixing sometime does crazy sounds. Try to use rubber or cork dumper between extruder and frame.
Mixing sometime does crazy sounds. Try to use rubber or cork dumper between extruder and frame.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Re: 'Singing' (and noisy) extruder
@Jarda3D, I'll give a shot to untigh a bit the screw on the frame althought I don't see why this one would be noisy and not the two others (unless it is unfunctional).
@William,
I'm not sure to understand the question. Do you mean the motherboard ?
In case of here a photo of the driver back:
@William,
I'm not sure to understand the question. Do you mean the motherboard ?
In case of here a photo of the driver back:
Re: 'Singing' (and noisy) extruder
Hi,the A4988 is :
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!